In those cold jittery winter mornings, taking a shower is mostly like a nightmare. Standing under the shower with cold water rushing through your body is the last thing you want when the temperature outside is minus degree. Only, hot water can save the day for you and let you enjoy the best bath possible. Even a warm shower can help you revitalize your energy and get some work going. But for that, you need a hot water heater. This is one of the most useful inventions ever made by mankind, and right now, it is hard to come across a place without such heaters. But, being a mechanical device, the heating elements inside the heaters might stop working sometimes, and you must get yourself a proper hot water heater repair from reputed teams. But sometimes, the issues are not that big to contact an expert and you can end up with some DIY tricks too.
Test the Heater First:
Even before you get your hands on the tools and start working on the repair, it is better to get the element tested first. For that, you don’t always need to have any electrical experience. But, one thing you must be very sure is to switch off the power even before you touch the heater. After switching off, you can perform any form of repair or test on the heater.
At first, you need to come across the circuit breaker in the main electrical panel. The one labeled for the water heater, ensure to switch it off. After that, check out the heater and test for some power with the help of voltage detector available. Remember to check whether the tester is working or not by just putting the tip into an outlet with power in it. This tester will always indicate power by just beeping or lighting up.
More on The Testing Part:
Once you are through with the basic services of hot water heater repair, now it is time to test wires, which are primarily leading to the heater. If the wires are covered with metal conduit, then the tester might fail to read voltage. During such instances, you might have to remove metal thermostat cover on one side of the heater and then pull the insulation. After that, hold the said tester near those wires, which are leading into the top of high temperature cutoff switches. Always remember to check out on both the hot wires before concluding. After that, hold the same voltage tester against metallic heater shell. In case, the tester fails to light up, it means you are safe to start testing elements.
Basic Diagnosis to Perform:
In case, the gas based heater fails to perform well, it means you need hot water heater repair right away! For that, performing some basic diagnosis is what you should be looking for.
- Always remember to check whether the gas to the heater is turned on.
- In case, the pilot light of the heater has gone out, try to follow the instructions available. If it is still not working, then you might have to ask for some repairs.
- Remember to check whether the burner is turned on or not. If it is on and still the water isn’t heating, then something is majorly wrong with the system.
Try to smell for gas. This will also ensure if you need a hot water heater repair now or not. There are so many problems, which you might face and finding the right solution for all of that is what you should be eyeing for.